Operating instructions

Empty the ice container the latest if the ice

container is filled up to 3/4 of its height

(see picture):

6. Turn the appliance off.

7. Take out the ice container.

ATTENTION: Turn the appliance off after

10 minutes to avoid overheating the motor

and let the motor cool down for 10 minutes.

The appliance is not intended for

permanent operation.

After use

8. If you are finished with your operation turn the appliance off and pull the plug.

9. Empty the feeding chute and the container.

IMPORTANT: If necessary and the crushing gear moves sluggish empty the feeding

chute according to the instructions ´Trouble Shooting`.

10. Clean the appliance and dry them carefully according to the instructions ´Care

and Cleaning`.

Care and Cleaning

Always clean the appliance right after use. WARNING – To avoid injury to persons

and damage, always turn the appliance ´OFF`, wait for the motor to stop completely

and unplug the appliance, immediately after operation and before assembling/

disassembling or cleaning the appliance. Do not place the appliance in an automatic

dishwasher or pour boiling water over it. Do not immerse the motor or power cord in any

liquids or spill any liquids on it or place the motor on wet surfaces.

1. Always turn the appliance ´OFF`, wait for the motor to stop completely, and

unplug the appliance from the power outlet before you start cleaning. Take the lid

off and remove leftover ice out of the feeding chute and the container (see ´Trouble

Shooting`). Put the empty ice container back in position.

2. If you have only crushed pure ice cubes you can move on to point 3.

Before first use or crushing ice with flavour, clean the feeding chute and the

crushing gear really carefully with a nylon washing brush.

ATTENTION: Do not use abrasive cleaners, cleaning pads, corrosive chemicals

(disinfectants, bleach) or any sharp or hard objects (i.e. metal scouring pads) for cleaning,

41127_elektr_design_eiscrusher_new_manual.qxp 20.12.2006 11:18 Seite 18