Design Multicook Plus Instruction Manual

75
Problem Possible Cause Solution of the problem
The cooking
temperature is not
high enough
You forgot to close the lid
of the appliance or the lid
was not tightly enough
closed, so that the cooking
temperature was not able
to develop high enough.
•Donotopenunnecessarythelidoftheap-
pliance during cooking.
•Closetheliduntilitclicksintoplace.Make
sure that nothing interferes with the closing of
the lid and the sealing ring on the inside of
the lid is not deformed.
The cooking bowl and the
heating element had poor
contact, so that the coo-
king temperature could
not be high enough.
•Theinnerpothastobehorizontallyinser-
ted into the housing and to fit snugly on the
heating element.
•Makesurethattherearenoforeignobjects
in the interior of the appliance. Check if the
heating element is clean.
The dishes do not
turn out well.
The selection of ingre-
dients, the way they were
cut and prepared, the
program selection and
the cooking time must
correspond to the selected
recipe.
•Theingredientsarenotsuitableforthese-
lected program.
•Theingredientsarecuttoolarge,orthege-
neral amount of ingredients was not observed.
•Youhavesetawrongcookingtime.
•The selectedrecipeisnot suitable forthe
preparation with this appliance.
- when steaming: There is too little water in
the inner pot to ensure a
sufficient vapour density.
Pour necessarily the recommended amount of
water in the recipe into the inner pot. When
in doubt, check the water level during the
cooking process.
- when frying and
deep-frying:
You have filled too much
oil into the inner pot.
•Usuallyitissufficientforfryingtowetthe
bottom of the inner pot with a thin coat of oil.
•Donotclosethelidwhilefrying,unlessitis
so specified in the recipe.
•Whenfrying,followtheinstructionsofyour
recipe.
•Excesswaterisintheinnerpot.
• Necessarily defrost frozen foods before
cooking and drain the water.
- when cooking:
e. g. broth boils
over during coo-
king process
The correct amounts of in-
gredients have not been
observed.
Follow the instructions and amounts as de-
scribed in your recipe. Make sure that all in-
gredients, are below the maximum mark (10
Cup) on the inner surface of the inner pot.
- when baking:
e. g. the dough is
not cooked well
baked
During the baking pro-
cess, a portion of the dou-
gh has stuck to the inside
of the lid and was blo-
cking the steam vent.
There is too much dough in the inner pot. Ad-
here to the recipes for this appliance.