Design Mincer Advanced (standard size 8) Owner manual

hardorstingilyingredients(forexample:bones,nuts,ginger).Ifyouusehardingredientslike
onions or carrots, you have to steam them before adding them to the meat otherwise they can
block the motor. If the motor or if the worm is blocked turn off the mincer (by turning the control
switch to STANDBY) and wait for approx. 6 seconds to be certain that the motor is no longer
running. Work according to the instructions ›Trouble shooting‹ before continuing operation.
•ATTENTION:Donotletthemotorrunpermanentlyforlongerthen15minutes
on maximumpowertoavoidoverheating.After15minutesturnofftheappli-
anceandletthemotorcooldownforseveralminutesbeforecontinuingopera-
tion.Withnormalloadthepermanentrunningtimeis30minutes.
Movableandsharp-edgedparts–riskofinjury
• Never put fingers, wooden spoons or other foreign objects (such as hair, clothing, brushes,
cloths) into the feed chute or the holes of the grinding disc when the appliance is plugged into the
power point. Always ensure that there are no foreign objects (such as bones, stems of vegeta-
bles or wooden spoons) in the feed chute before turning on the appliance. Only use the provided
pusher to push food through the feed chute. While proceeding donot
push the pusher too hard
down to avoid blocking the motor.
• Takecarehandlingthecrossed-bladeknifebecauseitisverysharp.
•Never hold your face or other body parts over the feed chute when the motor is running
because little pieces of food could be thrown out of the feed chute.
Importantsafeguardsforallelectricalappliances
• Alwaysunwindthepowercordcompletelybeforeinstallingtheappliance.
• Placetheapplianceclosetoapoweroutletandconnectitdirectlywithoutusinganyexten-
sion cords to avoid additional risks of injury through fire or voltage.
• Onlyinstalltheapplianceinproperformsecuregroundingreceptaclewithadequateelectric
power supply (alternating current; 230 V, 50 Hz) and ground fault circuit interrupter. You
should also install a fuse with a release current of maximum 30mA. If necessary ask your
electrician for help.
• Neverpull,rip,bend,clamp,squishorknotthepowercord.Payattentiontothepower
cord not hanging of the table. Attend to nobody getting caught in loops of the power cord
or pulling the appliance of the work space. When pulling the plug always catch hold of the
enclosure of the plug.
OPERATING
Before first use
Rinse all the parts of the appliance with water that come into contact with food and clean them
with dishwashing detergent. Operate according to the instructions ›Care and cleaning‹.
Assemblingtheappliance
WARNING: The work space has to be easily accessible, solid, even, dry and of sufficient
size. The mincer should only be set up on a firm level work surface. Never place the appli-
ance close to the edge of the working area. Ensure that the power supply cable does not hang
down from the work surface as it could be easily pulled, particularly by small children, thereby
23