Design Mincer Advanced (standard size 8) Owner manual

• Ensurethattheswitchandpowercorddonotcomeintocontactwithwater!Shouldthis
inadvertently happen, all parts must be completely dry before the appliance is used again.
• Never let water or other liquids run into the motor housing. Do not use the appliance
in moist and wet areas.
• Never clean the power cord or the appliance in the dishwasher, pour liquids over the
appliance or douse or dip it in water or other liquids. In case that water or other liquids ran into the
appliance while operating turn off the appliance immediately, pull the plug and dry the appliance
with a clean cloth (›Care and cleaning‹).
• Neverleavetheapplianceunattendedwhentheplugisconnectedtothe
poweroutlet.Always disconnect the power cord from the mains before assembling, dis-
mantling and cleaning the appliance or before exchanging the grinding discs. Always uncoil
the power cord completely before installing the appliance.
When pulling the plug always catch hold of the enclosure of the plug. Always grab hold on
both sides underneath the appliance when moving it or use the handle.
• Donotletthemotorrunlongerthennecessarytopreventoverheating.Afterturningoffthe
appliance the motor needs about 6 sec. to stop moving. Wait for the motor to stop completely
and press the power button before disassembling the appliance or continuing operation.
• Cleantheappliancestraightafteruseandrinseoffleftoverfood.Removesuchdirtimmedi-
ately and operate according to the instructions ›Care and cleaning‹ before storing the appli-
ance. Do not let food desiccate on the appliance.
• To avoid damage, do not use any abrasive cleaners, corrosive chemicals (i.e. dis-
infectants, bleach) or cleaning pads for operation or cleaning. Never clean or operate the
appliance or parts of the appliance with abrasive or hard sharp-edged items. Never put
themotorhousingortheaccessoriesintothedishwasherforcleaning!Thiswill
causediscolourationandcorrosionanddamagethemotor.
• Donotusetheapplianceifitisdamagedorpartsoftheappliancearedamaged.Donotuse
the appliance if it does not function properly or if it was excessively loaded. The appliance
is likely to be damaged if the appliance or parts of the appliance show cracks, exorbitant
wearing down, alterations or leaks. It is also likely to be damaged if the drive wheel of the
motor housing moves slowly. Take the appliance for technical maintenance and repair to
an authorised service center.
• Never use force assembling or disassembling the appliance. The single parts should be
put together easily. Only operate the mincer after it has been carefully assembled following
the instructions ›Assembling the appliance‹.
• Never use the crossed-blade knife and grinding disc in combination with the sausage filling
attachment and adaptor disc. Only use either the crossed-blade knife with the grinding disc or
the attachment.
• Alwaysturntheapplianceoff(byturningthecontrolswitchtoSTANDBY),waitforthemotor
to stop moving before pulling the plug or disassembling the mincer.
• Forthecasethat the worm housing or the closing ring loosen while operating turn off the
appliance immediately (by turning the control switch to STANDBY) and pull the plug. Operate
according to the instructions ›Trouble shooting‹ before turning the appliance on again.
• Themincermustonlybeusedtoprocessmeatandvegetables.Donotmincehardparts
such as bones. Do not mince hard-fibre foods such as ginger, etc. The mincer cannot mince
22 23