Design Mincer Advanced (standard size 8) Owner manual

MakingSausages

1. Prepare the meat according to the instructions in chapter ›Operating- Mincing meat‹.

Season the meat as desired.

2. Assemble the sausage attachment according to the instructions in chapter ›Assemble for

making sausages‹

3. Soak the sausage skin for 10 minutes in lukewarm water. Slide the sausage skin over the

sausage attachment.

Tip: If the skin gets stuck to the sausage attachment, wet it with some water.

4. As soon as the last bit has run through the appliance turn the appliance off (by turning the control

switch to STANDBY) and pull the plug.

5. Clean and disassemble the appliance right after use and make sure that no leftover

food desiccate on the appliance. Proceed according to the instructions in chapter ›Care and

cleaning‹.

CARE AND CLEANING

WARNING: Never hold your face or other body parts over the feed chute when the motor

is running because little pieces of food could be thrown out of the

feed chute. Never put foreign substance or hard objects into the feed

chute.

Before the mincer is used for the first time and after each use, all parts

– with the exception of the motor housing – must be thoroughly cleaned

in warm soapy water. In case of blockage proceed according to the

instructions in the ›Trouble shooting guide‹.

Disassemblingtheappliance

WARNING: To avoid injury and damages of the

applianceturnthe appliance off (by turning thecon-

trolswitchtoSTANDBY-pictureA)andthenwaitfor

approx.6secondstobecertainthatthemotorisno

longer running. Always pull the plug before you

startdisassemblingorcleaningtheappliance.

1. Switch off the mincer and disconnect the power supply cable

from the mains. Check that the motor has completely stopped.

2. Take the pusher and the feed pan of the feed chute.

3. Loosen the screw plug on the right side of the mincer by turn-

ing it counterclockwise until you can take the worm housing out

of the motor housing without any resistance (picture B).

4. Loosen the closing ring by turning it counterclockwise (picture

C). If the closing ring is screwed on too tight you can use the

provided spanner to loosen the closing ring.