GASTROBACK ® Instructions for use Mincer Art.-Nr.
! Carefully read all provided instructions before you start running the appliance and pay regard to the warnings mentioned in these instructions. Directions for Use Congratulations on the purchase of your new Gastroback Mincer and hope that it will soon convince you of its many advantages. You will soon find that the Gastroback Mincer is an exceptionally efficient and robust appliance for processing meat and vegetables.
Important safeguards for your Gastroback Design Mincer • Never clean the line cord or the appliance in the dishwasher, poor liquids over the appliance or douse or dip it in water or other liquids. In case that water or other liquids ran into the appliance while operating turn OFF the appliance immediately, pull the plug and dry the appliance with a clean cloth (´Care and cleaning`). Please read all the advice and instructions with care and keep the manual.
use the crossed-blade knife and mincer plate in combination with the chopper attachments. Only use either the crossed-blade knife with the mince plate or the chopper attachments at once. • For the case that the mincer head or the closing ring loosen while operating turn OFF the appliance immediately and pull the plug. Operate according to the instructions ´Trouble shooting` before turning the appliance ON again.
Operating - Mincing meat out the mincer head eventhough there is still meat in the feed funnel turn the mincer OFF and work according to the instructions ´Trouble shooting guide`. The mincer operates absolutely dependently and clean. If any problems should occur while operating act upon instructions ´Trouble shooting`. 6. As soon as the last bit is minced turn the appliance OFF and pull the plug.
IMPORTANT: Never assemble the appliance with the chopper attachment AND the crossed-blade knife with the mincer plate a. Assemble the mincer head in the opening of the drive shaft. Place the worm inside the mincer head (operate according to the instructions ´Assembling` the appliance. see fig. 1 and 2). b. Place the chopper attachment A on the axis of the worm. The slim end has to face the front (see fig. 7). Turn the chopper attachment a little bit while pushing it into the mincer head. c.
OFF the appliance immediately, pull the plug and dry the appliance with a clean cloth. Possible problem Easy solution 8. The motor block must only be wiped clean with a moist cloth. Do not clean the motor block under flowing water, nor should it be immersed in water! Do not use alcohol, benzine, etc.! The mincer blocks up permanently while operating. • To ensure that the mincer does not seize, never operate it under excessive pressure. Operate in a slow and constant pace.
Waste disposal The appliance has to be deposed by the definition of the regional waste disposal of electrical scrap. If necessary get information of the regional waste management enterprise. Warranty We guarantee that all our products are free of defects at the time of purchase. Any demonstrable manufacturing or material defects will be to the exclusion of any further claim and within 2 years after purchasing the appliance free of charge repaired or substituted.
