Brochure

FS™ I I  U
1) When using the XR3 fitting, proper removal of the outer jacket layer on FlashShield CSST is required for the
electrical continuity of the system. Using the Jacket Stripping Tool is the easiest way to achieve the correct
FlashShield end-prep condition and to ensure electrical continuity of the system.
2) Licensed Installers Only. Every installer of FlashShield
TM
must first meet all applicable qualifications in accordance
with state and/or local requirements as established by the administrative authorities that enforce the plumbing or
mechanical codes where gas piping is installed.
3) Qualified Installers Only. In addition to be licensed in the jurisdiction, FlashShield
TM
corrugated stainless steel
tubing (CSST) flexible gas piping material must only be installed by an installer who has been successfully trained
through the FlashShield
TM
training program.
4) Recertification. Installers must be recertified through the FlashShield
TM
training program every three (3) years.
5) Check for Updates. Installers must check with their local distributor or at www.gastite.com for technical bulletins
or updated Design & Installation Guides for FlashShield
TM
every one (1) year.
6) Proper Installation. Sound engineering principles and practices must be exercised for the proper design of fuel gas
piping systems, in addition to compliance with local codes. e installation instructions and procedures contained
in this Design & Installation Guide must be strictly followed in order to provide a safe and effective flexible fuel gas
piping system or system modification. All installations must pass inspections by the local official having authority
prior to having the gas service turned on. All requirements of the local natural gas utility or propane supplier must
also be met.
Proper FlashShield End Prep Proper XR3 Bushing Placement