Brochure

Gastite Division, Titeflex Corporation
1116 Vaughn Parkway / Portland, TN 37148
800.662.0208 / www.gastite.com / [e-mail]
101
April 2015
FS™ F G P
T P T
adminiStered only after completion of authorized flaShShield™ training courSe.
Circle the appropriate answer.
(Online Sections 1 & 2)
1) FlashShield CSST must be installed by a qualified
installer who has successfully completed the FlashShield
certification program.
True False
2) e Jacket Stripping Tool is used to achieve the
necessary end preparation of the FlashShield CSST to
the XR3 Fitting.
True False
3) FlashShield certifications have a _________ year
expiration date.
a) 1
b) 3
c) 5
4) In the event of a conflict between the FlashShield
Installation Guide and the local code the more stringent
requirement will take precedence.
True False
5) FlashShield CSST is approved for use at pressures
up to ____ PSI.
a) 5
b) 15
c) 25
6) FlashShield is approved for both natural gas and
propane.
True False
(Online Section 3)
7) Starting pressure, appliance input demands (pressure
and CFH), and length of run/longest run information
are all required to size gas piping systems.
True False
8) e longest run is the length of piping from the gas
source to the most remote appliance served by that gas
pressure source.
True False
9) Dual pressure systems will require the use of 2
separate sizing tables; one for the elevated pressure side
of the regulator and one for the low pressure side of
the regulator.
True False
10) Sizing tables can be found;
a) Within the FlashShield Installation Guide
b) On the Website
c) On the Gastite Mobile App
d) All of the Above
(Online Section 4)
11)
Clearance holes for routing FlashShield are to be
approximately ____ greater than the O.D. of the tubing.
a) ½
b) ¾
c) 1
12) FlashShield can be directly buried in the ground.
True False
13) FlashShield can be directly connected to a
moveable appliance.
True False
14) FlashShield shall not touch any portion of the metallic
cabinet of a fireplace.
True False
15) Gas lines with pressures above that of the maximum
input rating of the appliance must use a regulator.
True False
16) ere are no additional bonding requirements for
FlashShield required by the manufacturer; however,
FlashShield is to be bonded in the same manner as
rigid metal piping.
True False