Product Manual

4
DO NOT USE this appliance if it is leaking, damaged or
does not operate properly.
If you are unable to correct the leak by tightening the
connections, turn off the gas and contact the supplier
immediately.
Always ensure the appliance is kept away from
flammable materials and the gas cylinder clear of
any heat source. When changing over from an empty
gas cylinder to a full one make sure this procedure
is carried out in a well ventilated location, preferably
outside, away from people and away from any sources
of ignition; such as naked flames, pilot flames, electric
heaters/equipment.
SPECIFICATIONS
Appliance specifications can be found on the data label
attached to the appliance body.
GAS CYLINDER USE & SAFETY
This is a low pressure appliance and must only be used
with the hose and regulator supplied. This appliance
shall only be used with propane gas cylinders certified
to AS 2469. It may be hazardous to attempt to fit other
types of gas containers.
The gas cylinder should be filled by a reputable gas
supplier and visually inspected and re-qualified at each
filling.
Always keep cylinder in an upright position. Always
close the cylinder valve when the appliance is not in
use. Do not subject gas cylinder to excessive heat.
GAS INSTALLATION CODES
Appliance must be used in accordance with
the installation requirements of your gas supply
authority,
or the appropriate installation code issued by
Standards Australia AS 5601.
Appliances for use with bottled gas are labelled
‘propane gas’.
Only use on a non-combustible surface.
GAS INSTALLATION CODES
Appliance must be used in accordance with
the installation requirements of your gas supply
authority,
or the appropriate installation code issued by
Standards Australia AS 5601.
Appliances for use with bottled gas are labelled
‘propane gas’.
Only use on a non-combustible surface.
CLEARANCES
Minimum Clearances from combustible materials
must be: Cylinder - 500mm
Wall - 500mm
Above - 1200mm
Below - never use on a flammable surface.
Only use on a non-combustible surface.
Gas connection is 1/4” BSP
HOSE & REGULATOR SAFETY
The regulator and hose assembly supplied with the
appliance are suitable for propane gas only.
The pressure regulator and hose assembly supplied
with the appliance must be used. Replacement
pressure regulators and hose assemblies must be
those specified by the appliance manufacturer.
Only use the hose assembly supplied with this
appliance for direct connection to the cylinder
“DO NOT USE ADAPTORS”. Check the regulator
“O” Ring periodically for wear or damage and
replace if required.
When connecting the hose and regulator assembly
to the gas cylinder, take care to avoid unnecessary
twisting or kinking of the flexible hose. Maximum hose
length is 1 metre.
After the assembly has been secured, turn on the gas
and check for leaks by brushing a soap and water
solution overall connections.
GENERAL INFORMATION