User Guide

52
53CHAPTER THREE Inspection, Adjustment & Lubrication
To disconnect the shift cable
1. Put the shifter in 1st gear.
2. Pull the cable housing out of the shift cable housing stop.
3. Rotate the shift cable fixing bolt until the washer flats align
with the slit in the cog joint bracket.
4. Remove the cable.
To unbolt the axle from the frame
When loosening and tightening the axle nuts, do so gradually, in small
increments, to prevent effecting the bearing hub adjustment.
1. Slightly loosen the axle nut on one side of the hub by about
1/4 turn.
2. Slightly loosen the axle nut on the other side of the hub
about 1/4 turn.
3. Continue loosening the axle nuts in small increments until
you can slide the hub from the dropouts.
To install the wheel
1, Reverse the instructions for removing the wheel, including
gradual tightening of the axle nuts.
2. Reverse the procedure to connect the brake cable.
3. Reverse the procedure to connect the shift cable.
4. Check that the gear cable tension is correctly adjusted.
5. Follow the Inspection procedures in the Wheels section of
this chapter complete the installation.
Cable installation
Follow the instructions To install a brake cable, page 50.
Lubrication
Every 3 months lubricate the brake lever pivots with
Wrench Force synthetic chain lube or a similar light oil.
Whenever a brake cable is installed, lubricate the cable
with a thin layer of Wrench Force synthetic grease or a similar
lubricant.