User Guide

44
45CHAPTER THREE Inspection, Adjustment & Lubrication
To remove the rear wheel
1. With the derailleur, shift the chain to the
smallest rear cog.
2. Shift the rear hub to Uphill mode.
3. Push the Clickbox button (Figure 3.5.8) down.
4. Pull the Clickbox off the rear axle.
5. Screw out the shifting rod (Figure 3.5.9).
6. Follow the instructions To remove a wheel on
page 67.
To install the rear wheel
1. Follow the instructions To install a wheel on
page 67.
2. Screw in the shifting rod.
3. Place the Clickbox on the rear axle.
4. Push the Clickbox button.
5. Follow the instructions To adjust the rear hub shifting on
the previous page.
To replace the shift cable
1. Snap off the Clickbox cover (Figure 3.5.10).
2. Loosen the cable clamp bolt.
3. Note the path of the old cable, and remove the cable.
There is a snap-in plastic cover over the cable head in the
shifter.
3. Install a new cable in the shifter, housing, and
cable guides, following the old path.
4. Pull the cable snug and re-attach the cable
clamp bolt.
5. Re-attach the cover on the Clickbox.
6. Follow the instructions To adjust the rear hub
shifting on the previous page.
7. Crimp on a metal end-cap to prevent fraying
of the cable end, or apply some solder to the
end of the cable.
Lubrication
The DualDrive hub bearings are designed to be permanently
lubricated under normal use.
Whenever a cable is replaced, lubricate the cable with
Wrench Force
®
synthetic chain lube or a similar lubricant.
Figure 3.5.9 DualDrive shifting
rod and rear axle washers
Figure 3.5.10 DualDrive Clickbox
and cable clamp
Clickbox cover
Cable clamp bolt