Instructions / Assembly
WALL SLEEVE
INSTALLATION INSTRUCTIONS
SLEEVE HARDWARE
ITEM
DESCRIPTION
QT Y
1
BOTTOM COVER
1
2 1
3
4
LEFT COVER
1
1
1
INSTALL THE SLEEVE
Open the LEFT COVER and RIGHT COVER as shown
below.(See Fig.1)
INSTALL THE SLEEVE (CONTINUED)
Turn the SLEEVE as shown below.(See Fig.4)
2
5
Install the BOTTOM COVER with the LEFT COVER and
RIGHT COVER together by using 8 short screws as
shown below.(See Fig.3)
REMARK
3 4
TOP COVER
LONG/SHORT SCREW
5
RIGHT COVER
4/14
Install 6 short screws as shown below.(See Fig.2)
UNIT INSTALLATION
Fig.1
Fig.2
Fig.3
Fig.4
Lift unit level and slide unit into wall sleeve until firmly
against front of wall sleeve and secure with 4 long
screws through the unit flange holes. (See Fig.5 and
Fig.6)
NOTE:B 2 ,elow steps only for referenc detail steps
please refer to actual unit.
Fig.5
Fig.6
1
2
DRAIN KIT PARTS LIST
ITEM
DESCRIPTION
QT Y
1
COVER PLATE WITH DRAIN OUTLET
1
2
COVER PLATE(optional)
6
3
4
HOW TO INSTALL THE DRAIN KIT
You can choose outside drainage or inside drainage. See the following
procedures to perform outside drainage.
Attach foam gasket to cover plate as shown below.
Insert the bent tube into the cover plate with drain outlet as
shown below.
REMARE
2
5
FOAM GASKET WITH DRAIN OUTLET
1
1
2
3
HOW TO INSTALL THE DRAIN KIT (CONTINUED)
Install the cover plate with tube to the drain outlet located
at the back of the sleeve by using two screws and install the
cover plate without tube to the other drain outlet by using
two screws as shown below.
NOTE:The cover plate with tube may be placed on either
sied of the sleeve. Before tightening the screws,make sure
the tube s position will allow the sleeve to fit through the
wall.
BENT TUBE(optional)
DRAIN KIT (OPTIONAL)
INSTALLATION INSTRUCTIONS
6
6
6
SCREW ST3.9*14(optional)
STRAIGHT TUBE(optional)
1
3
4
4 5
Rotate the tube to the proper position as shown below.
See the following procedures to perform inside drainage.
Attach foam gasket to cover plate as shown below.
Insert the straight tube into the cover plate with drain outlet
as shown below.
First install