Installation Guide
INSTALLATION INSTRUCTIONS
Wall Sleeve Brands:
#9 White Westinghouse or Frigidaire
( 22 Deep)
2. Place two (2) 1 x1 x14 seals against each side.
3. Gently slide unit in and check if amount extend-
ing from the sleeve is sufficient once the trim
frame is attached.
4. If position is okay, remove unit and proceed to
the next step. If not, go to step 8.
5. Attach one (1)1 x1 x15 seal to each of the
side sleeve.
6. Cut one (1) 1 x1 x25 seal to 14 long and
attach it vertically to the rear grille 4.5 from
the left side. Repeat this process and attach
the second seal
7. Attach one (1) 1 x1 x25 seal in the center at
the top of the sleeve. Remove the backing paper
and press into position. Proceed to step 14.
Use these next steps if the unit requires extra
extension into the room.
8. Attach a 1 x x14 seal over the solid
vertical portion of the rear grille.
9. Attach four (4) 4 x3 x1 foam blocks with the
slot overlapping the seal above.
10. Install the divider into the slots of the foam
blocks. You may need to trim the length to size.
11. Repeat steps 8-10 for the other vertical
portions of the grille as shown.
12. Attach two (2) 1 x1 x14 seals along the sides
of the sleeve, making sure all seals are flush.
13.Cut the 1 x1 x25 seal to fit the top of the
sleeve. The pieces must be flush against the
edge of the divider.
14. Center unit and gently slide it into sleeve.
15. Before sliding all the way back, remove first
screw from front left side of unit.
16. Remove the plastic washer from the screw.
17. Screw and attach the other end of the ground
wire to the unit as shown. Make sure that the
toothed washer is against the cabinet.
18.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
19.Seal and frame the unit as described on page 17.
20. If you have difficulty with mounting the grille to
the sleeve, follow the instructions for direct
mounting on Page 16.
Because of the increased unit depth, first try
dry fitting using the method described below:
1
/
2
1
/
2
1
/
2
1
/
2
3
/
4
1
/
2
1
/
2
1
/
2
1
/
2
1
/
2
1.
6
7
11
8
10
12
9
13
Remove existing rear grille as shown on Page
6 of this manual and replace with provided
louvered rear panel. Install as shown here.
NOTE: You may need to drill holes in flange
of existing sleeve to match new rear grille.
5
6
4
4
4
4
3
8
3
8
4 from the right side.
4
4
15