Installation Guide

INSTALLATION INSTRUCTIONS

Wall Sleeve Brands:

#6 Whirlpool 17 Deep

1. Remove existing rear grille as shown on Page

6 of this manual and replace with provided

louvered rear panel. Install as shown here.

NOTE: You may need to drill holes in flange of

existing sleeve to match new rear grille.

2. Cut two (2) 17 tapered spacer blocks as shown

below into two pieces.

3. Install 13 section to the floor of the sleeve as

shown. This helps induce a rearward slope on the

unit.

4. Attach one (1) 1 x3/8 x25 seal in the center

at the top of the sleeve. Remove the backing

paper and press into position.

5. Attach two (2) 1 x3/8 x14 seals to the left and

right sides of the sleeve.

6. Cut two (2) 1 x3/8 x25 seals to 14 long and

attach them to the vertical sections of the rear

grille as shown.

7. Center unit and gently slide unit into sleeve.

8. Before sliding all the way back, remove second

screw from front left side of unit.

9. Remove the plastic washer from the screw.

10. Screw and attach the other end of the ground

wire to the unit as shown in picture. Make sure

that the toothed washer is against the cabinet.

11.Slide the unit completely to the rear to ensure

a good seal, making sure the ground wire does

not

become tangled.

12.Seal and frame the unit as described on page 17.

13. If you have difficulty with mounting the grille to

the sleeve, follow the instructions for direct

mounting on Page 16.

Tapered Spacer Block

Protection Paper

Backing

Cut Here