Installation Guide

INSTALLATION INSTRUCTIONS
Wall Sleeve Brands:
#3 Fedders or Friedrich 16 Deep
1.Remove existing rear grille as shown on Page
6 of this manual and replace with provided
louvered rear panel. Install as shown here.
NOTE: You may need to drill holes in flange of
existing sleeve to match new rear grille.
3
4
/
2. Attach one (1) 4 x3 x1 centering/support block
on each side wall. Place in center of side
wall with the tapered end facing the opening.
3. Cut two (2) 17 tapered spacer blocks as shown
below into three pieces.
4. Place the 2- section in front of the rib on
base with the tapered end facing the back of
the sleeve. Cut the remaining portion to 12
and placed behind the rib, sloping toward
the rear of the sleeve. This helps induce a
rearward slope on the unit.
5. Attach one (1) 1 x3/8 x25 seal in the center
at the top of the sleeve. Remove the backing
paper and press into position.
6. Attach two (2) 1 x3/8 x14 seals to the left and
right sides of the sleeve.
7. Cut two (2) 1 x3/8 x25 seals to 14 long and
attach them to the vertical sections of the rear
grille as shown.
8. Gently slide unit into sleeve.
9. Before sliding all the way back, remove second
screw from front left side of unit.
10. Remove the plastic washer from the screw.
11. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make
sure
that the toothed washer is against the cabinet.
12.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
13.Seal and frame the unit as described on page 17.
14. If you have difficulty with mounting the grille to
the sleeve, follow the instructions for direct
mounting on Page 16.
1
/
2
1
/
2
/
2
1
/
2
/
2
Cut Here
3
/
4
17
Tapered Spacer Block
1
Protection Paper
Backing
12-1/2
2-1/2
1
/
2
1
/
2
5
4 4
4
4
3
8
3
8
9