Installation Guide

NORMAL USE

Connect the charging cable to the EV.

If authorization is activated, please hold a valid RFID-tag against the RFID reader on the side of the LS4 you want to use or use the

operator app to authorize charging.

Charging will start instant if the EV is ready for charging. See your EV charging manual.

When finishing charging, follow the EV’s instructions.

After charging: Release the charging cable from your EV and place the charging cable at designated place.

Firm

No car connected Charging station available and ready for charging

Car connected State B: Car connected but not yet ready for charging

Car connected State C: Car connected and ready for charging, but charging

station requires authentication to start charging (Free Charging =

"OFF").

Blinking (3 blinks)

When car connects The charging station detects that the cable is connected, but is

yet to detect the car.

Blinking (30

second blink)

Whenever during operation Charging station have received command from backend to start

charging and is waiting for car to connect.

Firm

Car connected Charging is ongoing (state C)

Car connected Charging is paused (state B)

Blinking

Whenever during operation Charging station/point is reserved for a specific user

Firm

Whenever during operation DC fault monitor may be defect.

Whenever during charging Residual Circuit Current Breaker (RCCB) triggered.

Whenever during charging DC fault detected.

Whenever during charging Circuit breaker (MCB) triggered - Overload / short circuit

Whenever during charging Type 2 connector motor locking was released/unlocked (the

cable can be removed)

When connecting car The socket outlet can not engage locking mechanism to lock the

connector.

When connecting car Charging cable is damaged.

light on RIGHT

side

Whenever during operation The right side charge controller have lost connection to left side

charge controller.

Firm (3 seconds)

When RFID is presented RFID card is not valid or not approved by backend.

Blinking

Whenever during operation Charging station/point is deactivated.

Blinking

When RFID is presented Charging station is verifying the RFID in backend cloud service.

LED light indication When Cause of error