Instruction Manual
Table Of Contents
- Important Safety Information
- Tools Needed
- Mounting Considerations
- Installing the Transducer on the Perspective Mode Mount
- Installing the Transducer on a Trolling Motor Barrel
- Installing the Transducer on the Trolling Motor Shaft
- Installing the Transducer Using Low Profile Mounting Hardware
- Installing the Transducer on a Pole
- Mounting the GLS 10 Black Box Device
- Transducer Settings and Operation
- Appendix
Viewing Mode Examples on the Starboard Side
Perspective view (notches and )
Forward view (notches and )
Downward view (notches and )
You should align the marks on the transducer and extension arm to verify the appropriate orientation before
tightening the knob.
Installing the Transducer on a Trolling Motor Barrel
Labels identifying the parts bags required for this procedure:
NOTICE
You must secure the transducer cable to the shaft or other secure location during installation. Damage to the
transducer cable wires or cable jacket can cause transducer failure.
1 Remove the rubber liner from parts bag .
2 Remove the hose clamp and trolling motor barrel mount from parts bag .
9