Instruction Manual

Viewing Modes
Using the perspective mode mount and extension arm, you can change the orientation angle of the transducer
between three sonar views.
When installing the transducer using the recommended adjustment knobs, no tools are necessary to change the
orientation between these three fields of view. You must loosen the knobs to change the orientation of the arm
and transducer, and tighten them to set the orientation.
You can verify the sonar view using the notches on the perspective mount bracket, the shaft mount, and the
transducer.
NOTE: The notches are not labeled on the transducer hardware, so you can use these tables and diagrams
to understand the positioning of the transducer and perspective view bracket when changing between sonar
views.
and
Port downward view
and
Port forward view
and
Perspective view
and
Starboard forward view
and
Starboard downward view
7