Instruction Manual

6 If you are installing the transducer on a trolling motor shaft equal to or less than 25mm (1in.) in diameter,
wrap the rubber liner around the shaft in the location where you want to install the mount.
NOTE: The rubber liner is not needed when installing the transducer on a trolling motor with a shaft diameter
that is larger than 25mm (1in.), such as the Garmin Force
®
trolling motor.
7 Orient the mounting bracket on the shaft so the arrows on the inside of the front half of the bracket point
upward.
The bracket should be aligned so the center screw hole faces the front of the trolling motor.
8 Place the bracket around the rubber liner on the trolling motor shaft, insert the screws into the mount
bracket, and secure them using the M6 hex wrench.
9 (Optional) Transition the trolling motor from the deployed to the stowed position and back again to test the
location of the mounting bracket, and make any adjustments as needed.
10 Hold the extension arm so the 90-degree angle points downward, and attach the shorter length of the
extension arm to the mounting bracket using the shorter knob .
11 Place the transducer below the longer length of the extension arm, and attach it using the longer knob .
NOTE: You can attach the extension arm to the mounting bracket and attach the transducer to the extension
arm using the included low-profile hardware instead of the knobs if you do not plan to switch transducer
modes frequently during use (Installing the Transducer Using Low Profile Mounting Hardware, page14).
12 Secure the transducer cable to the motor shaft or other secure location.
13 Route the transducer cable to the installation location of the sonar module, while taking these precautions.
• You must route the cable so it does not come in contact with the propeller when the trolling motor is
operating.
• You should not route the cable close to electrical wires or other sources of electrical interference.
• You must route the cable so it is not pinched when the trolling motor is deployed or stowed.
NOTE: If necessary, for extra cable length, you can connect an optional extension cable, available at buy
.garmin.com
or from your Garmin dealer.
14 Position the transducer at your desired angle (Viewing Modes, page7).
6