Instruction Manual

Table Of Contents

Installing the Transducer on the Perspective Mode Mount

Labels identifying the parts bags required for this procedure:

NOTICE

You must secure the transducer cable to the shaft or other secure location during installation. Damage to the

transducer cable wire or the cable jacket can cause transducer failure.

NOTE: To avoid obstructions in the sonar image, you should mount the transducer on the shaft as far from the

motor as possible.

1 Remove the perspective mode extension arm, the front half of the mounting bracket, and the short knob from

parts bag .

2 Remove the back half of the mounting bracket, the M6 hex wrench, and four screws from parts bag .

3 Remove the long knob from parts bag .

4 If the trolling motor shaft is equal to or less than 25mm (1in.) in diameter, remove the rubber liner from

parts bag .

5 Identify the arrow on the front half of the

mounting bracket to ensure that you orient the

bracket with the wide end of the slant at the top

when you attach the bracket to the trolling motor

shaft.

NOTE: The perspective mode bracket has an 11-

degree angle to allow the extension arm to transition

between all three sonar views.