Instruction Manual
Table Of Contents
- Important Safety Information
- Tools Needed
- Mounting Considerations
- Installing the Transducer on the Perspective Mode Mount
- Installing the Transducer on a Trolling Motor Barrel
- Installing the Transducer on the Trolling Motor Shaft
- Installing the Transducer Using Low Profile Mounting Hardware
- Installing the Transducer on a Pole
- Mounting the GLS 10 Black Box Device
- Transducer Settings and Operation
- Appendix
Installing the Ferrite Bead on the Transducer Cable
NOTICE
To comply with FCC regulations, and with similar regulations of other countries if applicable, and to reduce
electromagnetic interference (EMI) or "noise," you should install a ferrite bead on each transducer cable.
1 Position the included ferrite bead on the transducer cable, near the connector.
2 Snap the ferrite bead securely around the transducer cable.
Using the Optional Split Collar
If you plan to drill a hole or need to route the cable through a tight space during installation, you can remove the
existing solid locking collar on the cable before routing it. After routing the cable to the final location, you can
install the included split locking collar before making the connection.
1 Use side-cutting pliers to cut through the existing solid collar.
NOTE: Take care when cutting the existing collar to avoid damaging the cable or the connector.
2 Remove the solid collar from the cable connector and save the existing o-ring if it is not damaged.
3 Route the cable to the connection location.
4 If needed, separate the two pieces of the optional split collar.
5 Snap the pieces together around the cable connector.
6 Insert either the original o-ring or the included replacement o-ring around the connector and into the collar.
4