Instruction Manual

Port side, downward view
Port side, forward view
Starboard side, downward view
Starboard side, forward view
Installing the Transducer Using Low Profile Mounting Hardware
If you do not plan to change the viewing mode of the transducer often, or prefer a lower-profile installation
without the adjustment knobs, you can use the included hardware to install the transducer instead of using the
knobs.
Labels identifying the parts bags required for this procedure:
1 Secure the mounting bracket to the trolling motor barrel (Installing the Transducer on a Trolling Motor Barrel,
page9) or shaft (Installing the Transducer on the Trolling Motor Shaft, page11) (Installing the Transducer on
the Perspective Mode Mount, page5) according to the appropriate instructions, but do not use the included
adjustment knobs.
2 Select an action:
• If you are installing the transducer on the barrel or shaft of the trolling motor, use the longer low-profile
screw and metal washer from parts bag to secure the transducer to the mounting bracket.
• If you are installing the transducer using the perspective mode mount and extension arm, use the shorter
low-profile screw and metal washer from parts bag to secure the extension arm to the mounting
bracket, and use the longer low-profile screw and metal washer from parts bag to secure the
transducer to the extension arm.
3 Adjust the view of the transducer and tighten the low-profile screws using the M5 hex wrench in parts bag
.
14