Instruction Manual

11 Secure the transducer cable to the motor shaft or other secure location.
12 Route the transducer cable to the installation location of the sonar module while taking these precautions.
• You must route the cable so that it does not come in contact with the propeller when the trolling motor is
operating.
• You should not route the cable close to electrical wires or other sources of electrical interference.
• You must route the cable so it is not pinched when the trolling motor is deployed or stowed.
NOTE: If necessary, for extra cable length you can connect an optional extension cable, available at buy
.garmin.com or from your Garmin dealer.
13 Position the transducer to your desired angle, and tighten the knob (Installing the Transducer on the Trolling
Motor Shaft, page11).
Trolling Motor Shaf Mount Orientation
The orientation angle depends on which side of the trolling motor shaft you mount the bracket on, and your
desired field of view.
When installing the transducer using the recommended adjustment knob, no tools are necessary to change the
orientation from forward to downward, or vice versa. You must loosen the knob to change the orientation and
tighten it to set the orientation.
NOTE: You should align the marks as shown on the transducer and mount to verify the appropriate orientation
before tightening the knob.
13