Instruction Manual

Table Of Contents

4 Identify the arrow on the front half of the shaft

mount bracket to ensure that you orient the bracket

with the narrow end of the angle at the top when

you attach the bracket to the trolling motor shaft.

5 If you are installing the transducer on a trolling motor

shaft equal to or less than 25mm (1in.) in diameter,

wrap the rubber liner around the shaft in the

location you want to install the mount.

NOTE: The rubber liner is not needed when installing the transducer on a trolling motor with a shaft diameter

that is larger than 25mm (1in.), such as the Garmin Force trolling motor.

6 Place the shaft-mount bracket around the rubber liner on the trolling motor shaft.

7 Insert the screws into the shaft mount bracket and secure them using the M6 hex wrench in parts bag

8 (Optional) Transition the trolling motor from the deployed to the stowed position and back again to test the

location of the mounting bracket and make any adjustments as needed.

9 Remove the knob from parts bag .

10 Attach the transducer to the mount using the knob

, and tighten the knob by hand.

NOTE: You can secure the transducer to the mount using the included low-profile hardware instead of the

knob if you do not plan to switch transducer modes frequently during use (Installing the Transducer Using

Low Profile Mounting Hardware, page14).