Instruction Manual
Table Of Contents
- Important Safety Information
- Tools Needed
- Mounting Considerations
- Installing the Transducer on the Perspective Mode Mount
- Installing the Transducer on a Trolling Motor Barrel
- Installing the Transducer on the Trolling Motor Shaft
- Installing the Transducer Using Low Profile Mounting Hardware
- Installing the Transducer on a Pole
- Mounting the GLS 10 Black Box Device
- Transducer Settings and Operation
- Appendix
Port side, downward view
Port side, forward view
Starboard side, downward view
Starboard side, forward view
Installing the Transducer on the Trolling Motor Shaf
Labels identifying the parts bags required for this procedure:
NOTICE
You must secure the transducer cable to the shaft or other secure location during installation. Damage to the
transducer cable wire or the cable jacket can cause transducer failure.
NOTE: To avoid obstructions in the sonar image, you should mount the transducer on the shaft as far from the
motor as possible.
1 Remove the back of the shaft-mount bracket and four screws from parts bag .
2 Remove the front half of the shaft mount bracket from parts bag .
3 If the trolling motor shaft is equal to or less than 25mm (1in.) in diameter, remove the rubber liner from
parts bag
.
11