Instruction Manual

3 Insert the hose clamp through the slot on the trolling motor mount until equal lengths extend on both
sides of the mount.
4 Place the rubber liner against the trolling motor barrel where you plan to secure the mount.
5 Secure the hose clamp around the trolling motor barrel using a flat screwdriver or 8mm wrench or socket.
6 Remove the knob from parts bag .
7 Attach the transducer to the mount using the knob , and tighten the knob by hand.
NOTE: You can secure the transducer to the mount using the included low-profile hardware instead of the
knob if you do not plan to switch transducer modes frequently during use (Installing the Transducer Using
Low Profile Mounting Hardware, page14).
8 Secure the transducer cable to the motor shaft or other secure location.
9 Route the transducer cable to the installation location of the sonar module while taking these precautions.
• You must route the cable so that it does not come in contact with the propeller when the trolling motor is
operating.
• You should not route the cable close to electrical wires or other sources of electrical interference.
• You must route the cable so it is not pinched when the trolling motor is deployed or stowed.
NOTE: If necessary, for extra cable length you can connect an optional extension cable, available at buy
.garmin.com or from your Garmin dealer.
10 Position the transducer to your desired angle (Trolling Motor Barrel Mount Orientation, page10).
Trolling Motor Barrel Mount Orientation
The orientation angle depends on which side of the trolling motor you have mounted the transducer on, and
your desired field of view.
When installing the transducer using the recommended adjustment knob, no tools are necessary to change the
orientation from forward to downward, or vice versa. You must loosen the knob to change the orientation and
tighten it to set the orientation.
NOTE: You should align the marks as shown on the transducer and mount to verify the appropriate orientation
before tightening the knob.
10