Pro Trashbreaker Owner’s Manual March 2014 190-01726-00_0B Printed in Taiwan
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product. All rights reserved.
Getting Started WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Attaching the Dog Collar Device to the Collar Strap 1 With the buckle À facing outward, insert the end of the collar strap through the slot Á on the collar device. Setting Up the Pro Trashbreaker System Before you can use the Pro Trashbreaker system, you must set up the devices.
Charging the Collar NOTICE To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the charging clip. You should fully charge the battery before you use the device for the first time or whenever the battery is low (Checking the Battery Level). It is normal for the battery to discharge in approximately 7 to 10 weeks when the device is not in use. Charging a fully depleted battery takes about 2 hours.
Sometimes dogs will vocalize due to the surprise of the electrical stimulation. If the dog vocalizes more than once, the intensity level is too high for beginning training. 4 If there is no reaction, increase the intensity level by one level until the dog has a slight but recognizable reaction to the stimulation. The intensity level that causes a slight but recognizable reaction is your dog's baseline level for beginning collar training.
Device Information Pro Trashbreaker Handheld Device Specifications Battery type Rechargeable, replaceable lithium-ion Battery life 60 hours typical use Operating temperature range From -4° to 140°F (from -20° to 60°C) Charging temperature range From 32° to 104°F (from 0° to 40°C) Storage temperature range From -4° to 104°F (from -20° to 40°C) Water rating IEC 60529 IPX7* Wireless range 4 mi. (6.4 km) 3 Remove the screw Á securing the VHF antenna to the back plate.
4 Grip the rotary switch connector wires close to the connector, and pull the connector perpendicular to the circuit board to disconnect the rotary switch connector from the device. 5 Remove the two screws from the battery plate. 6 Lift up the battery plate. 7 Remove the old battery from the back plate, noting the orientation of the battery. The battery fits tightly. It may be necessary to pry the battery out of the back plate using a non-sharp, non-metal object.
When properly installed, the connector plug snaps into the port. 12 Replace the front plate, and replace and tighten the six screws to secure the front plate. 13 Replace the screw securing the VHF antenna to the back plate. 14 Replace the cover over the VHF antenna. 15 Replace the three screws on the cover. 16 Verify the gasket is not sticking out of the device. Getting More Information You can find more information about this product on the Garmin website. • Go to www.garmin.com/outdoor.
www.garmin.com/support 913-397-8200 1-800-800-1020 0808 238 0000 +44 (0) 870 8501242 1-866-429-9296 +43 (0) 820 220230 + 32 2 672 52 54 +385 1 5508 272 +385 1 5508 271 +420 221 985466 +420 221 985465 + 45 4810 5050 + 358 9 6937 9758 + 331 55 69 33 99 + 39 02 36 699699 (+52) 001-855-792-7671 0800 0233937 +47 815 69 555 00800 4412 454 +44 2380 662 915 (+35) 1214 447 460 +386 4 27 92 500 0861 GARMIN (427 646) +27 (0)11 251 9999 +34 93 275 44 97 +49 (0)180 6 427646 20 ct./Anruf. a. d.
