Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Piper PA-46 Meridian
190-01842-00 Rev. A
Index
139
Flight
Instruments EICAS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
3) Turn the system ON. A prompt is displayed.
4) Press the YES Softkey. The navigation database is copied to the SD card in
the bottom card slot of the MFD.
5) After the navigation database files are copied to the bottom SD card, press
any key to verify, as instructed.
6) After database verification is complete, press any key to continue as
instructed on the display.
7) Press the NO Softkey. The display now starts in normal mode. Since the
database effective date is not yet valid, it should not be loaded as the
active database. The display now starts in normal mode. Do not remove
power while the display is starting.
8) Press the ENT Key to acknowledge the startup screen.
9) Turn the large FMS Knob to select the AUX Page group on the MFD.
10) Turn the small FMS Knob to select the System Status Page.
11) The new database is copied to the SD card in the bottom card slot of each
PFD. Progress can be monitored in the SYNC STATUS field. When copying
is finished, ‘Complete’ is displayed.
NOTE: During the synchronization process, version differences between
standby navigation databases will exist. This will result in the system
displaying a ‘DB Mismatch’ alert for the standby navigation databases. This
alert will remain until the next power cycle.
12) Turn system power OFF.
13) Remove the SD card from the top card slot of the MFD.
14) Turn system power ON.
15) Press the ENT Key to acknowledge the startup screen.
16) Turn the large FMS Knob to select the AUX Page group on the MFD.