Pilot's Guide

190-01461-00 Rev. A
Garmin G1000 Pilot’s Guide for the Piper PA-44-180 Seminole
23
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
OBS Selects OBS Mode on the CDI when navigating by GPS (only available with active
leg)
CDI Cycles through GPS, VOR1, and VOR2 navigation sources on the HSI
DME Displays the DME Tuning Window, allowing tuning and selection of the DME
(optional)
XPDR Displays transponder mode selection softkeys:
STBY Selects standby mode (Transponder does not reply to any interrogations)
ON Selects Mode A (Transponder replies to interrogations)
ALT Selects Mode C – altitude reporting mode (Transponder replies to identification and
altitude interrogations)
GND Manually selects Ground Mode (Transponder does not allow Mode A and Mode C
replies, but does permit acquisition squitter and replies to discretely addressed Mode
S interrogations)
VFR Automatically enters the VFR code (1200 in U.S.A. only)
CODE Displays transponder code selection softkeys 0-7
0 — 7 Use numbers to enter code
BKSP Removes numbers entered, one at a time
ADS-B TX Enables/disables automatic transmission of ADS-B position and speed.
IDENT Activates the Special Position Identification (SPI) pulse for 18 seconds, identifying the
transponder return on the ATC screen
TMR/REF Displays/removes Timer/References Window
NRST Displays/removes Nearest Airports Window
MSG Displays/removes Messages Window
Press the BACK Softkey to return
to the top-level softkeys.
Press the BACK Softkey to return
to the top-level softkeys.
XPDR
STBY ON ALT VFR IDENT BACKADS-B TX MSGCODE
IDENT BACK
MSG
0 1 2 3 4 5 6 7 BKSP
BACK
Press the BACK Softkey to return
to the top-level softkeys.
DCLTR
DCLTR-2
DCLTR-3
DCLTR-1
WX LGND
TOPO
MSG
NEXRAD
(optional)
TERRAIN
XM LTNG METAR
(optional)
(optional)
OFF
INSET
STD BARO
BACK
MSG
WIND
HSI FMT
PFD
BRG
1
BRG2
Press the BACK Softkey to return
to the top-level softkeys.
ALT UNIT
DFLTS
Press the BRG1/BRG2
softkeys to display/remove
the Bearing Information
windows and cycle through
bearing sources:
- NAV1/NAV2
- GPS
GND
INSET XPDR IDENT TMR/REF NRST MSGOBSPFD CDI
Press the CDI Softkey to cycle through
navigation sources:
- GPS
- NAV1 (VOR/LOC)
- NAV2 (VOR/LOC)
DME
(optional)
DME
(optional)
SYN VIS
(optional)
HPA BACK
MSG
METERS IN
BACK
MSG
OPTN1 OPTN2 OPTN3 OFF
BACK
MSG
360 HSI
ARC HSI
TRFC-1
TRFC-2
MSG
SYN TERR
HRZN HDG
PATHWAY
APTSIGNS
Figure 1-18 XPDR Softkeys