Cockpit Reference Guide

Embraer Prodigy
®
Touch Flight Deck 300 Cockpit Reference Guide
190-01536-00 Rev. A 87
Hazard Avoidance
Flight
Instruments EAS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
3) Press the Joystick. This enables the Joystick to set the Bearing Line
position and displays a bearing and tilt Joystick legend.
4) Push the Joystick left or right to place the Bearing Line on the desired
storm cell or other area to be vertically scanned. When finished, press the
Joystick again to disable the bearing line adjustment Joystick function.
5) Touch the Scan Button.
6) Touch the Vertical Button. The Weather Radar display shows a vertical
scan.
7) Push the Joystick left or right as needed to move the bearing line a few
degrees left or right.
8) Turn the Joystick to adjust the range as needed.
9) To select a new area to be vertically scanned, return to the Horizontal scan
mode.
a) Touch the Scan Button.
b) Touch the Horizontal Button.
c) Return to Step 2 of this procedure.
Adjusting antenna tilt on the Weather Radar Display in Horizontal
Scan Mode:
1) Push the Joystick to activate the tilt adjustment function of the Joystick.
The Weather Radar displays a bearing and tilt Joystick legend.
2) Use the Joystick to adjust the antenna tilt angle.
3) Press the Joystick again to disable the tilt adjustment function of the
Joystick and remove the legend.
Ena bling/Disabling Altitude Compensated Tilt (ACT):
1) From Home, touch Weather > Weather Selection > WX RADAR > WX
RADAR Settings.
2) Touch the Altitude Comp Tilt Button. Feature is enabled when button
annunciator is green, disabled when gray.