Pilot's Guide

Garmin G1000H
™
Pilot’s Guide for the Bell 407GX 190-01255-01 Rev. A 507
ADDITIONAL FEATURES
Send a transmission manually:
1) While viewing the Maintenance Logs Page, press the FMS Knob to activate the cursor.
2) Turn the large FMS Knob to display the list of available folders.
3) Turn either FMS Knob to select the desired folder.
4) Press the ENT Key.
5) Turn the large FMS Knob to place the cursor on the ‘EXPORT’ button to the right of the log file to be transmitted.
6) Press the ENT Key.
7) Turn the large FMS Knob to place cursor on ‘SELECT EXPORT MODE’ field.
8) Turn the small FMS Knob to display the export mode options as seen in Figure 8‑117.
Figure 8-117 Select Transmit
9) Turn the small FMS Knob to select ‘TRANSMIT’.
10) Press the ENT Key.
11) Turn the large FMS Knob to place the cursor in the ‘SELECT DATA TO EXPORT’ field as shown in Figure 8‑118.
Figure 8-118 Select Which Data to Export
12) Turn the small FMS Knob to display the selection options, as in Figure 8‑118. In this example, ‘COMPLETE LOG’
is selected. This option sends all the data contained in the file. Choosing ‘NEW DATA ONLY’ will send only new
data not sent in previous transmissions.
13) Press the ENT Key. The ‘OK’ Button is highlighted. To cancel the transmission, select the ‘CANCEL’ Button.