Pilot's Guide

Garmin G1000H
™
Pilot’s Guide for the Bell 407GX 190-01255-01 Rev. A506
ADDITIONAL FEATURES
14) Turn the either FMS Knob to place the cursor on the desired transmit type option.
15) Press the ENT Key.
16) The next steps vary based on the previous selection. Perform the following based on the transmit type selected.
a) Select ‘AUTOMATIC’ as the transmission type. Data is transmitted when specific alert triggers become valid.
Turn the large FMS Knob to select the ‘ALERT (ID)’ field.
b) Using the FMS Knobs, enter the appropriate alert ID (provided by the aircraft manufacturer) as shown in Figure
8‑113.
c) Press the ENT Key.
Figure 8-113 Enter Alert ID Figure 8-114 Enter Transmit Time Period
Or:
a) Select ‘PERIODIC’ as the transmission type. Data is transmitted at specific time intervals. Turn the large FMS
Knob to select the ‘PERIOD’ field.
b) Using the FMS Knobs, enter the desired time interval (hours, minutes, and seconds) as seen in Figure 8‑114.
c) Press the ENT Key.
Or:
Select ‘IMMEDIATE’ as the transmission type. Data is transmitted immediately after it is logged.
Or:
Select ‘Manual’ as the transmission type. Data is transmitted only when the ‘EXPORT’ Button associated with a
specific log file selected.
17) With the cursor in the ‘PRIORITY’ field, use the FMS Knobs to enter the desired value as in Figure 8‑115.
18) Press the ENT Key. The cursor is now displayed in the ‘RETRY COUNT’ field.
Figure 8-115 Enter Priority Value Figure 8-116 Enter Number of Transmit Retries
19) Use the FMS Knobs to enter the number of times the system will try to connect to a Wi‑Fi network or make a
connection to the Iridium system. See Figure 8‑116.
20) Press the ENT Key.
21) Press the small FMS Knob to remove the Folder Transmission Settings Window from the display.