Pilot's Guide

190-01255-01 Rev. A
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
39
SYSTEM OVERVIEW
inlet
When the Particle Separator or Snow Baffle is installed on the engine air inlets, the system must adjust
the algorithms used to calculate the Power Assurance Check. This is accomplished by selecting these
options in the Inlet Box of the System Setup 1 Page.
To enable/disable the Particle Separator and/or Snow Baffle option:
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the desired option eld in the Inlet Box.
3) Turn the small FMS Knob one click to the right to select ON or one click to the left to select OFF.
PilOt PROFiles
System settings may be saved under a pilot profile. When the system is powered on, the last selected
pilot profile is shown on the MFD power-up screen (Figure 1-6). The G1000H can store up to 25 profiles;
the currently active profile, the amount of memory used, and the amount of memory available are shown
at the top of the System Setup 1 or System Setup 2 Page in the box labeled ‘Pilot Profile’. From here, pilot
profiles may be created, selected, renamed, or deleted.
Figure 1-29 Pilot Profiles (System Setup Page)
Creating a profile:
1) Turn the large FMS Knob to select the AUX Page group.
2) Turn the small FMS Knob to select System Setup.
3) Press the FMS Knob momentarily to activate the flashing cursor.
4) Turn the large FMS Knob to highlight ‘CREATE’ in the Pilot Prole Box.
5) Press the ENT Key. A ‘Create Profile’ window is displayed.
6) Use the FMS Knob to enter a profile name up to 16 characters long and press the ENT Key. Pilot profile names
cannot begin with a blank as the first letter.