Pilot's Guide

Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
190-01255-01 Rev. A390
HAZARD AVOIDANCE
Figure 6-110 Navigation Map Page Setup Menu
Figure 6-111 Navigation Map Page Setup Menu, Traffic Group
Figure 6-109 Navigation Map Page
Menu
TheNavigationMapPageSetupMenuprovidesameansinadditiontothesoftkeyforenabling/disabling
display of trafc.  The setup menu alsocontrols the map range settings above which trafc data (symbols
andlabels)aredeclutteredfromthedisplay.Ifamaprangelargerthanthemaprangesettingisselected,the
dataisremovedfromthemap.MapsbesidestheTrafcMapPageusesettingsbasedonthoseselectedforthe
NavigationMapPage.
TRAFFIC MAP PAGE
TheTrafcMapPageisspecializedtoshowsurroundingTIStrafcdatainrelationtotheaircraft’scurrent
positionandaltitude,withoutclutterfromthebasemap.ItistheprincipalmappageforviewingTISinformation.
Aircraftorientationonthismapisalwaysheadingupunlessthereisnovalidheading.Maprangeisadjustable
with the RANGE Knobfrom2to12nm,asindicatedbythemaprangerings.
ThetrafcmodeisannunciatedintheupperleftcorneroftheTrafcMapPage.Whentheaircraftisonthe
ground,TISautomaticallyentersStandbyMode.Oncetheaircraftisairborne,TISswitchesfromStandbyto
OperatingModeandtheG1000Hbeginstodisplaytrafcinformation.RefertotheSystemStatusdiscussion
for more information.
Displaying traffic on the Traffic Map Page:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Confirm TIS is in Operating Mode:
Select the OPERATE Softkey to begin displaying traffic.