Pilot's Guide

Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
190-01255-01 Rev. A270
FLIGHT MANAGEMENT
3) Turn the large FMS Knob to select the ‘MID AFT’ PRESENT field. Turn the small FMS Knob to select ‘NO’. The
new weight will be reflected in the Basic Empty Weight shown at the top of the page.
4) Press the GO BACK Softkey to return to the AUX - WEIGHT & BALANCE Page. The executive configuration will
be shown in the AIRCRAFT LOAD window.
When the aircraft is in the air and a destination waypoint has been entered, the fuel calculations can be
completed.
•‘EST LANDING WEIGHT’ = zero fuel weight + estimated landing fuel weight.
•‘EST LANDING FUEL’ = fuel on board weight - (fuel flow x ETE)
•‘EXCESSFUEL’=estimatedlandingfuelweight-fuelreservesweight
If the aircraft is on the ground or a destination waypoint has not been entered, the following fields display
invalid values consisting of four dashes:
•‘ESTLANDINGWEIGHT’
•‘ESTLANDINGFUEL’
•‘EXCESSFUEL’
WEIGHT AND BALANCE CAUTION AND WARNING CONDITIONS
If the ‘ZERO FUEL WEIGHT’ is greater than the maximum allowable zero fuel weight, then the zero fuel
weight is displayed in yellow.
Ifthe‘GROSS WEIGHT’ is greater than the maximum allowable takeoff weight, then the gross weight is
displayed in yellow.
Ifthe‘EST LANDING WEIGHT’ is greater than the maximum allowable landing weight, then the estimated
landing fuel weight is displayed in yellow.
Ifthe‘ESTLANDINGFUEL’weightispositive,butlessthanorequaltothefuelreservesweight,thefollowing
values are displayed in yellow:
•‘EST LANDING FUEL’ weight
•‘EXCESSFUEL’weight
Ifthe‘EST LANDING FUEL’ weight is zero or negative, then the following values are displayed in red:
•‘EST LANDING FUEL’ weight
•‘EXCESSFUEL’weight
Ifthe‘LONSTA’isoutsidethespeciedCGenvelope,thenthelongitudinalstationvalueisdisplayedinred,
and the longitudinal CG Slider Gauge outline will be red.
Iftheexpectedfuelburnwillplacethe‘LONSTA’outsideofthespeciedCGenvelope,thenthelongitudinal
station value is displayed in yellow, and the longitudinal CG Slider Gauge outline will be yellow.
Ifthe‘LATSTA’isoutsidethespeciedCGenvelope,thenthelateralstationvalueisdisplayedinred,andthe
lateral CG Slider Gauge outline will be red.
Iftheexpectedfuelburnwillplacethe‘LATSTA’outsideofthespeciedCGenvelope,thenthelateralstation
value is displayed in yellow, and the lateral CG Slider Gauge outline will be yellow.