Pilot's Guide

190-01255-01 Rev. A
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
125
AUDIO PANEL AND CNS
DME TUNING
NOTE: When turning on the system for use, the system remembers the last frequency used for DME tuning
and the NAV1 , NAV2, or HOLD state prior to shutdown.
TheDMEtransceiveristunedbyselectingNAV1,NAV2,orHOLDintheADF/DMETuningWindow.
Figure 4-33 DME Tuning Window
DME
Modes
ThefollowingDMEtransceiverpairingscanbeselected:
•NAV1–PairstheDMEfrequencyfromtheselectedNAV1frequency.
•NAV2–PairstheDMEfrequencyfromtheselectedNAV2frequency.
•HOLD – When in the HOLD position, the DME frequency remains pairedwith the last selected NAV
frequency.
Selecting DME transceiver pairing:
1) Select the ADF/DME Softkey to display the ADF/DME Tuning Window.
2) Turn the small FMS Knob to select the DME tuning mode.
3) Press the ENT Key to complete the selection.
Pressing the CLR Key or FMS Knob while in the process of DMEpairingcancelsthedataentryandreverts
backtothepreviouslyselectedDMEtuningstate.PressingtheFMS Knob activates/deactivates the cursor in
theADF/DMETuningWindow.