Pilot's Guide
190-01255-01 Rev. A
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
38
SYSTEM OVERVIEW
Changing the CDI range:
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the SELECTED eld in the GPS CDI Box.
3) Turn the small FMS Knob to display and scroll through the range list and press the ENT Key when the desired
selection is highlighted.
4) Press the FMS Knob to deactivate the cursor.
cOm cOnFigURatiOn
NOTE
: 8.33 kHz VHF communication frequency channel spacing is not approved for use in the United States.
Select the 25.0 kHz channel spacing option for use in the United States.
The COM Configuration Box on the System Setup 1 Page allows the pilot to select 8.33 kHz or 25.0 kHz
COM frequency channel spacing.
To change COM channel spacing:
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the channel spacing eld in the COM Conguration Box.
3) Turn the small FMS Knob to select the desired spacing and press the ENT Key.
neaRest aiRPORts
The Nearest Airports Box on the System Setup 1 Page defines the minimum runway length and surface
type used when determining the nine nearest airports to display on the MFD Nearest Airports Page. A
minimum runway length and/or surface type can be entered to prevent airports with small runways or
runways that are not of appropriate surface from being displayed. Default settings are zero feet (or meters)
for runway length and “HARD/SOFT” for runway surface type.
To select nearest airport surface matching criteria (any, hard only, hard/soft, water):
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the runway surface eld in the Nearest Airports Box.
3) Turn the small FMS Knob to display and scroll through the runway options (any, hard only, hard/soft, water) and
press the ENT Key when the desired selection is highlighted.
To select nearest airport minimum runway length matching criteria:
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the minimum length eld in the Nearest Airport Box.
3) Turn the FMS Knobs to enter the minimum runway length (zero to 99,999 feet) and press the ENT Key.