Pilot's Guide

Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
190-01255-01 Rev. A400
HAZARD AVOIDANCE
SYSTEM TEST
NOTE: Traffic surveillance is not available during the system test. Use caution when performing a system
test during flight.
Thetrafcsystemprovidesasystemtestmodetoverifythesystemisoperatingnormally.Thetesttakesten
secondstocomplete.Whenthesystemtestisinitiated,atestpatternoftrafcsymbolsisdisplayedonthe
TrafcMapPage(Figure6-118).Thevoicealert“TAS System Test Passed” or “TAS System Test Failed” is
issuedwhenthetestiscomplete,andthetrafcsystemwillbeinStandbyMode.
Testing the traffic system:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Turn the Range knob to set the range to 2/6 nm to allow for the full test pattern to be displayed.
4) Select the TEST Softkey.
Or:
1) Press the MENU Key and turn the small FMS knob to select ‘Test Mode’.
2) Press the ENT Key.
TA at 9 o’clock,
Distance 2.0
nm, 200’ Below,
Climbing
Non-Threat
Traffic at
11 o’clock,
Distance 3.6
nm, 1000’
Above, Level
Proximity
Traffic at
1 o’clock,
Distance
3.6 nm,
1000’ Below,
Descending
Operating
Mode
Test Mode
Annunciation
Figure 6-118 System Test in Progress with Test Pattern