Pilot's Guide

Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
190-01255-01 Rev. A370
HAZARD AVOIDANCE
Figure 6-89 Stormscope Page
Stormscope
Operating
Mode
Stormscope
Lightning Strike
Rate
Range Marking
Indications
Changing between ‘cell’ and ‘strike’ mode:
1) Select the Stormscope Page.
2) Select the MODE Softkey. The CELL and STRIKE softkeys are displayed.
3) Select the CELL Softkey to display ‘CELL’ data or select the STRIKE Softkey to display ‘STRIKE’ data. ‘CELL’ or
‘STRIKE’ is displayed in the mode box in the upper left corner of the Stormscope Page.
4) Press the BACK Softkey to return to the Stormscope Page.
Or:
1) Select the Stormscope Page.
2) Press the MENU Key.
3) Turn the small FMS Knob to choose between ‘CELL’ and ‘STRIKE’ options.
4) When an item is selected, press the ENT Key.
If heading input is lost, strikes and/or cellsmustbeclearedmanually after the execution of each turn
(Figure6-90).Thisistoensurethatthestrikeand/orcellpositionsaredepictedaccuratelyinrelationtothe
nose of the aircraft.
Manually clearing Stormscope data (on the Stormscope Page):
1) Select the Stormscope Page.
2) Press the MENU Key.
3) Select ‘Clear Lightning Data’ (Figure 6-90).