Pilot's Guide

190-01255-01 Rev. A Garmin G1000H
™
Pilot’s Guide for the Bell 407GX 130
AUDIO PANEL AND CNS
Pressing the CLR Key or small FMS Knob before code entry is complete cancels code entry and restores the
previouscode.Waitingfor10secondsaftercodeentryisnishedactivatesthecodeautomatically.
Figure 4-41 Entering a Code with the FMS Knob
Press the
ENT Key to
Complete
Code Entry
Turn the Large
FMS Knob
to Move the
Cursor to the
Next Code Field
Turn the Small
FMS Knob to
Enter Two Code
Digits at a Time
VFR CODE
The VFRcodecanbe enteredeithermanuallyorbypressing the XPDR Softkey, then the VFR Softkey.
Whenthe VFR Softkeyispressed,thepre-programmedVFRcodeisautomaticallydisplayedinthecodeeld
oftheTransponderDataBox.Pressingthe VFR Softkey again restores the previous identification code.
Thepre-programmedVFRCodeissetatthefactoryto1200.IfaVFRcodechangeisrequired,contacta
Garmin-authorizedservicecenterforconguration.
Figure 4-42 VFR Code
VFR Code
IDENT FUNCTION
NOTE: In Standby Mode, the IDENT Softkey is inoperative.
Pressing the IDENT Softkey sends a distinct identity indication to Air Traffic Control (ATC). The indication
distinguishes the identing transponder from all the others on the air traffic controller’s screen. The IDENT
Softkey appears on all levels of transponder softkeys.  When the IDENT Softkey is pressed, a green IDNT
indicationisdisplayedinthemodeeldoftheTransponderDataBoxforadurationof18seconds.
After the IDENT Softkey is pressed while in Mode or Code Selection, the system reverts to the top-level
softkeys.
Press the IDENT
Softkey to Initiate
the ID Function
IDNT
Indication
Figure 4-43 IDENT Softkey and Indication