Pilot's Guide

190-01255-01 Rev. A

Garmin G1000H

™

Pilot’s Guide for the Bell 407GX

552

APPENDIX B

The ChartView database should be copied to the Garmin supplied Supplemental Data Card which will reside

in the bottom card slot on the MFD. The navigation database must be installed from the Jeppesen or user

supplied SD data card. Contact Jeppesen (www.jeppesen.com) for subscription and update information.

NOTE: After the navigation database is installed, the card may be removed.

Updating the active Jeppesen navigation database (not using the Dual Navigation Database or

Automatic Database Synchronization Features):

1) With the system OFF, insert the SD card containing the new navigation database version into the top card slot of the

display (PFD or MFD) to be updated (label of SD card facing left).

2) Turn the system ON. A prompt similar to the following is displayed in the upper left corner of the display:

Figure B-1 Standby Navigation Database Prompt

3) Press the NO Softkey to proceed to loading the active database.

4) A prompt similar to the following is displayed, press the YES Softkey to update the active navigation

database.

Figure B-2 Database Update Conﬁrmation

5) After the update completes, the display starts in normal mode. Do not remove power while the display is

starting.

6) Turn the system OFF and remove the SD card from the top card slot.

7) Repeat steps 1 through 6 for the other display (PFD or MFD). Remove the SD card when ﬁnished.