Pilot's Guide

Garmin G1000H
™
Pilot’s Guide for the Bell 407GX 190-01255-01 Rev. A 505
ADDITIONAL FEATURES
to use the second method, ‘TX MODE 2’. The system will attempt to connect using mode 1 through 4 until a
connection is successful.
Figure 8-110 Set Transmission Mode Settings
7) Turn the small FMS Knob to display the available transmission settings as shown in Figure 8‑111.
Figure 8-111 Set Transmission Method Settings
8) Turn the either FMS Knob to the desired transmission setting. Selecting ‘WI‑FI’, as Figure 8‑111 shows, will set
the system to transmit log data over a Wi‑Fi network when the system connects using ‘TX MODE 1’. Selecting
‘SAT SHORT BURST’ or ‘SAT RUDICS’ will set the system to use one of the two Iridium telephone system options
for transmission. Selecting ‘NONE’ will disable the transmit mode.
9) Press the ENT Key to complete the selection.
10) Turn the large FMS Knob to move the cursor to the ‘TX MODE 2’ field.
11) Repeat steps 7 through 9 to set the transmission methods for transmit modes 2 through 4.
12) Turn the large FMS Knob to move the cursor to the ‘TX TYPE’ field.
13) Turn the small FMS Knob to display the list of transmit type options as in Figure 8‑112.
Figure 8-112 Select Transmit Type