Cockpit Reference Guide

Garmin G1000
®
Cockpit Reference Guide for the Cessna CitationJet Model 525
190-01130-00 Rev. A
46
Hazard Avoidance
Flight
InstrumentsEIS
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
AlertsAppendixIndex
5) Select the STANDBY Softkey to place the system in the Standby Mode.
‘STANDBY’ is displayed in the Traffic Mode field.
6) Rotate the Joystick clockwise to display a larger area or rotate counter-
clockwise to display a smaller area.
7) Select the FLT ID Softkey to enable or disable Flight ID displayed with the
intruder information.
System Self Test
1) With the Traffic Map Page displayed, set the range to 2/6 nm.
2) Select the STANDBY Softkey.
3) Select the TEST Softkey.
4) Self test takes approximately eight seconds to complete. When completed
successfully, traffic symbols are displayed and a voice alert “TAS System Test
OK” is heard. If the self test fails, the system reverts to Standby Mode and
a voice alert “TAS System Test Fail” is heard.
Displaying Traffic on the Navigation Map
1) Ensure TAS is operating.
2) With the Navigation Map displayed, select the MAP Softkey.
3) Select the TRAFFIC Softkey. Traffic is now displayed on the map.
TERRAIN AWARENESS & WARNING SYSTEM
TAWS-A (Optional)
WARNING: The TAWS display shows supplemental information only. It should
not be used for navigation.
NOTE: Terrain data is not displayed when the aircraft latitude is greater than
75 degrees north or 60 degrees south.
NOTE: TAWS operation is only available when the system is configured for
a TAWS-A installation.