Cockpit Reference Guide

Garmin G1000
®
Cockpit Reference Guide for the Cessna CitationJet Model 525
190-01130-00 Rev. A 11
Nav/Com/XPDR/Audio Panel
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
NAV/COM/TRANSPONDER/AUDIO PANEL
ENTER OR CHANGE FLIGHT ID
1) Press the TMR/REF Softkey, then turn the large FMS Knob to highlight the
Flight ID field.
2) Turn the small FMS Knob to enter the first character.
3) Turn the large FMS Knob to select the next field.
4) Turn the small FMS Knob to enter the next desired character.
5) Repeat steps 3 and 4 until the desired Flight ID is entered.
6) Press the ENT Key to update the Flight ID.
ADF TUNING (OPTIONAL)
1) Tune the ADF using the remote ADF control head.
2) If two ADF systems are installed, press the AUX Key on the desired audio
panel to monitor ADF2 audio.
DME TUNING
1) Press the DME Softkey.
2) If two DMEs are installed, turn the large FMS to select the DME source
field.
3) Turn the small FMS Knob to select the desired Nav radio.
4) Press the ENT Key to complete the selection.
5) If two DMEs are installed, press the AUX Key on the desired audio panel to
monitor DME2 audio.
ENTER A TRANSPONDER CODE
1) Press the XPDR Softkey to display the transponder mode selection softkeys.
2) Press the XPDR1 or XPDR2 Softkey to select the active transponder.
3) Press the CODE Softkey to display the transponder code selection softkeys,
for digit entry.
4) Press the digit softkeys to enter the code in the code field. When entering
the code, the next key in sequence must be pressed within 10 seconds, or
the entry is cancelled and restored to the previous code. Five seconds after
the fourth digit has been entered, the transponder code becomes active.