Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Diamond DA40NG
190-00953-02 Rev. A 73
Annunciations & Alerts
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
GIA 63 MESSAGE ADVISORIES (CONT.)
Message
Comments
GIA1 SERVICE – GIA1 needs service.
Return the unit for repair.
The GIA1 and/or GIA2 self-test has detected a
problem in the unit. The G1000 system should
be serviced.
GIA2 SERVICE – GIA2 needs service.
Return the unit for repair.
MANIFEST – GIA1 software mismatch,
communication halted.
The GIA1 and/or GIA 2 has incorrect software
installed. The G1000 system should be serviced.
MANIFEST – GIA2 software mismatch,
communication halted.
MANIFEST – GFC software mismatch,
communication halted.
Incorrect servo software is installed, or gain
settings are incorrect.
MANIFEST – COM1 software
mismatch, communication halted.
COM1 and/or COM2 software mismatch. The
G1000 system should be serviced.
MANIFEST – COM2 software
mismatch, communication halted.
MANIFEST – NAV1 software
mismatch, communication halted.
NAV1 and/or NAV2 software mismatch. The
G1000 system should be serviced.
MANIFEST – NAV2 software
mismatch, communication halted.
COM1 TEMP – COM1 over temp.
Reducing transmitter power.
The system has detected an over temperature
condition in COM1 and/or COM2. The transmit-
ter is operating at reduced power. If the problem
persists, the G1000 system should be serviced.
COM2 TEMP – COM2 over temp.
Reducing transmitter power.
COM1 SERVICE – COM1 needs service.
Return unit for repair.
The system has detected a failure in COM1 and/
or COM2. COM1 and/or COM2 may still be us-
able. The G1000 system should be serviced when
possible.
COM2 SERVICE – COM2 needs service.
Return unit for repair.
COM1 PTT – COM1 push-to-talk key is
stuck.
The COM1 and/or COM2 external push-to-talk
switch is stuck in the enable (or “pressed”)
position. Press the PTT switch again to cycle its
operation.
If the problem persists, the G1000 system should
be serviced.
COM2 PTT – COM2 push-to-talk key is
stuck.