Cockpit Reference Guide
Table Of Contents
- Flight Instruments
- Selecting the Altimeter Barometric Pressure Setting
- Selecting Standard Barometric Pressure
- Change Altimeter Barometric Pressure Setting Units
- Synchronizing the Altimeter Barometric Pressure Settings
- Synchronize CDI
- Change Navigation Sources
- Enable/Disable OBS Mode While Navigating with GPS
- Generic Timer
- Configure Vspeed Bugs Individually
- Turn Vspeed Bugs On or Off by Category
- Set Barometric/Radar Altimeter (Optional) Minimum Descent Altitude
- Displaying Wind Data
- Engine & Airframe Systems
- Nav/Com/Transponder/Audio Panel
- Automatic Flight Control System
- GPS Navigation
- Flight Planning
- Weight Planning
- Trip Planning
- Create a New User Waypoint Defined by Latitude & Longitude
- Create a New User Waypoint Defined by Radials from Other Waypoints
- Create a New User Waypoint Defined by a Radial & Distance from Another Waypoint
- Delete a User Waypoint
- Create a New Flight Plan
- Import a Flight Plan from an SD Card
- Insert a Waypoint in the Active Flight Plan
- Enter an Airway in a Flight Plan
- Invert An Active Flight Plan
- Remove a Departure, Arrival, Approach, or Airway from a Flight Plan
- Store a Flight Plan
- Edit a Stored Flight Plan
- Delete a Waypoint from the Flight Plan
- Invert and Activate a Stored Flight Plan
- Copy a Flight Plan
- Delete a Flight Plan
- Graphical Flight Plan Creation
- Export a Flight Plan to an SD Card
- Procedures
- Hazard Avoidance
- Additional Features
- Abnormal Operation
- Annunciations & Alerts
- CAS Messages
- Comparator Annunciations
- Reversionary Sensor Annunciations
- TAWS-A Alerts
- TAWS-B Alerts
- TCAS I Alerts and Annunciations
- TCAS II Alerts and Annunciations
- Other Prodigy® Aural Alerts
- Flight Plan Import/Export Messages
- MFD & PFD Message Advisories
- Database Message Advisories
- GMA 1347D Message Advisories
- GIA 63W Message Advisories
- GSD 41 Message Advisories
- GEA 71 Message Advisories
- GTX 33/33D Message Advisories
- GRS 77 Message Advisories
- GMU 44 Message Advisories
- GSR 56 Message Advisories
- GDL 59 Message Advisories
- GDL 69A Message Advisories
- GWX 68 Alert Messages
- GDC 74B Message Advisories
- GCU 475 Message Advisories
- GMC 715 Message Advisories
- GTS 850 Message Advisories
- Miscellaneous Message Advisories
- Appendix
- Index
Cockpit Reference Guide for the Prodigy
®
Flight Deck 100
190-00685-03 Rev. A
Appendix
153
Flight
Instruments EAS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
5)
Acknowledge the Power-up Page agreement by pressing the ENT Key or
the right most softkey.
6)
Turn the large FMS Knob to select the AUX Page group on the MFD.
7)
Turn the small FMS Knob to select the System Status Page.
8)
Make sure the SYNC DBS Softkey is in the enabled state.
9)
Monitor the Sync Status in the Database Window. Wait for all databases to
complete synching, indicated by ‘Complete’ being displayed.
10)
Remove and reapply power to the system.
11)
Turn the large FMS Knob to select the AUX Page group on the MFD.
12)
Turn the small FMS Knob to select the System Status Page.
13)
Select the Display Database Selection Softkey to show database information
for each display (MFD1 DB, PFD1 DB). Verify the correct database cycle
information is shown for each database for each display.
Canceling an automatic database synchronization:
1)
While synchronization is in progress, select the SYNC DBS Softkey to
disable (Figure B-2) automatic database synchronization.
2)
Acknowledge the cancelation by pressing the ENT Key.
Loading the Jeppesen navigation database:
NOTE: Loading the Jeppesen navigation database prior to its effective date
will result in the expiration date on the power-up screen and the effective
date on the AUX-System Status Page being displayed in yellow.
1)
Copy the new navigation database to an SD card obtained from Garmin, or
the aircraft manufacturer.
2)
With the Prodigy
®
system OFF, insert the SD card containing the new
navigation database version into the top card slot of the MFD (label of SD
card facing left).
3)
Turn the Prodigy
®
system ON. A prompt similar to the following illustration
is displayed: