Cockpit Reference Guide

Garmin G1000 Pilot’s Guide for the Piper PA-46 Meridian
190-00763-02 Rev. A370
HAZARD AVOIDANCE
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
TAWS-Binformationcanbedisplayedonthefollowingmaps:
•PFDInsetMap
•NavigationMapPage
•TAWS-BPage
•TripPlanningPage
•FlightPlanPage
•SystemPage
Displaying terrain and obstacle information (maps other than the TAWS-B Page):
1) Select the MAP Softkey (for the PFD Inset Map, select the INSET Softkey).
2) Select the TERRAIN Softkey to display terrain and obstacle data.
WhenTAWS-BisselectedonmapsotherthantheTAWS-BPage,anicontoindicatethefeatureisenabledfor
displayandalegendforTAWS-Bterraincolorsareshown(Figure6-83).
Figure 6-83 TAWS-B Icon and Legend
TheNavigationMapPageSetupMenuprovidesameansinadditiontothesoftkeyforenabling/disabling
displayofterrainandobstacles.Thesetupmenualsocontrolsthemaprangesettingsabovewhichterrainand
obstacledataaredeclutteredfromthedisplay.Ifamaprangelargerthanthemaprangesettingisselected,the
dataisremovedfromthemap.Forterraindata,theenable/disablefunctionappliesonlytotheMFD,whilethe
rangesettingalsoaffectsthePFDInsetMap.
Terraindatacanbeselectedfordisplayindependentlyofobstacledata;however,obstaclesforwhichwarnings
and cautions are issued are shown when terrain is selected for display and the map range is within the setting
limit.
Maps besides the TAWS-B Page use settings based on those selected for the Navigation Map Page.  The
maximumdisplayrangesforobstaclesoneachmaparedependentontherangesettingmadefortheNavigation
Map.IfthemaximumrangeforobstacledisplayontheNavigationMapisadjustedtobelow20nm,thehighest
obstacledisplayrangesettingsontheotherapplicablemapsarealsoadjustedproportionally.
Customizing terrain and obstacle display on the Navigation Map Page:
1) Select the Navigation Map Page.
2) Press the MENU Key.
3) With ‘Map Setup’ highlighted, press the ENT Key (Figure 6-84).
4) Turn the small FMS Knob to select the ‘Map’ Group and press the ENT Key (Figure 6-85).
5) Turn the large FMS Knob or press the ENT Key to scroll through product selections (Figure 6-86).
• TERRAIN DATA – Turns the display of terrain data on or off and sets maximum range at which terrain is shown