Cockpit Reference Guide

190-00763-02 Rev. A Garmin G1000 Pilot’s Guide for the Piper PA-46 Meridian 24
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
DFLTS
Resets PFD to default settings, including changing units to standard
WIND
Displays softkeys to select wind data parameters
OPTN 1
Headwind/tailwind and crosswind arrows with numeric speed components
OPTN 2
Wind direction arrow and numeric speed
OPTN 3
Wind direction arrow with headwind/tailwind and crosswind numeric speed
components
OFF
Information not displayed
DME
Displays/removes the DME Information Window (optional)
BRG1
Cycles the Bearing 1 Information Window through NAV1, GPS/ waypoint identifier
and GPS-derived distance information, and ADF/frequency.
HSI FRMT
Displays the softkeys for selecting the two HSI formats
360 HSI
Displays HSI as a 360° compass rose
ARC HSI
Displays HSI as a 140° viewable arc
BRG2
Cycles the Bearing 2 Information Window through NAV2 or GPS waypoint identifier
and GPS-derived distance information, and ADF/frequency.
ALT UNIT
Displays softkeys for setting the altimeter and BARO settings to metric units
METERS
When enabled, displays altimeter in meters
IN
Press to display the BARO setting as inches of mercury
HPA
Press to display the BARO setting as hectopacals
STD BARO
Sets barometric pressure to 29.92 in Hg (1013 hPa if metric units are selected)
OBS
Selects OBS mode on the CDI when navigating by GPS (only available with active
leg)
CDI
Cycles through GPS, VOR1, and VOR2 navigation modes on the CDI
DME
Displays the DME Tuning Window, allowing tuning and selection of the DME
(optional)
XPDR
Displays transponder mode selection softkeys
XPDR1
Selects the #1 transponder as active
XPDR2
Selects the #2 transponder as active
STBY
Selects standby mode (transponder does not reply to any interrogations)
ON
Selects Mode A (transponder replies to interrogations)
ALT
Selects Mode C – altitude reporting mode (transponder replies to identification and
altitude interrogations)
GND
Manually selects Ground Mode, the transponder does not allow Mode A and
Mode C replies, but it does permit acquisition squitter and replies to discretely
addressed Mode S interrogations
VFR
Automatically enters the VFR code (1200 in the U.S.A. only)
CODE
Displays transponder code selection softkeys 0-7
0 — 7
Use numbers to enter code
BKSP
Removes numbers entered, one at a time