Cockpit Reference Guide

190-00763-02 Rev. A
Garmin G1000 Pilot’s Guide for the Piper PA-46 Meridian
359
HAZARD AVOIDANCE
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
Terrain-SVSinformationcanbedisplayedonthefollowingmaps:
•PFDInsetMap
•NavigationMapPage
•Terrain-SVSPage
•TripPlanningPage
•FlightPlanPages
•SystemPage
Displaying terrain and obstacle information (maps other than the Terrain-SVS Page):
1) Select the MAP Softkey (for the PFD Inset Map, select the INSET Softkey).
2) Select the TERRAIN Softkey to display terrain and obstacle data.
WhenTerrain-SVSisselectedonmapsotherthantheTerrain-SVSPage,anicontoindicatethefeatureis
enabledfordisplayandalegendforTerrain-SVSterraincolorsisshown.
TheNavigationMapPageSetupMenuprovidesameansinadditiontothesoftkeyforenabling/disabling
displayofterrainandobstacles.Thesetupmenualsocontrolsthemaprangesettingsabovewhichterrainand
obstacledataaredeclutteredfromthedisplay.Ifamaprangelargerthanthemaprangesettingisselected,the
dataisremovedfromthemap.Forterraindata,theenable/disablefunctionappliesonlytotheMFD,whilethe
rangesettingalsoaffectsthePFDInsetMap.
Terraindatacanbeselectedfordisplayindependentlyofobstacledata;however,obstaclesforwhichwarnings
and cautions are issued are shown when terrain is selected for display and the map range is within the setting
limit.
MapsotherthantheTerrain-SVSPageusesettingsbasedonthoseselectedfortheNavigationMapPage.The
maximumdisplayrangesforobstaclesoneachmaparedependentontherangesettingmadefortheNavigation
Map.IfthemaximumrangeforobstacledisplayontheNavigationMapisadjustedtobelow20nm,thehighest
obstacledisplayrangesettingsontheotherapplicablemapsarealsoadjustedproportionally.
Customizing terrain and obstacle display on the Navigation Map Page:
1) Select the Navigation Map Page.
2) Press the MENU Key.
3) With Map Setup highlighted, press the ENT Key (Figure 6-72).
4) Turn the small FMS Knob to select the Map Group and press the ENT Key (Figure 6-73).
5) Turn the large FMS Knob or press the ENT Key to scroll through product selections (Figure 6-74).
• TERRAIN DATA – Turns the display of terrain data on or off and sets maximum range at which terrain is shown
• OBSTACLE DATA – Turns the display of obstacle data on or off and sets maximum range at which obstacles are shown
6) Turn the small FMS Knob to scroll through options for each product (ON/OFF, range settings).
7) Press the ENT Key to select an option.
8) Press the FMS Knob or CLR Key to return to the Navigation Map Page with the changed settings.