Cockpit Reference Guide

190-00763-02 Rev. A Garmin G1000 Pilot’s Guide for the Piper PA-46 Meridian 130
AUDIO PANEL AND CNS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
Figure 4-33 Transponder Softkeys (PFD)
Selecting the BACK Softkey
returns to the top-level softkeys.
Selecting the BACK Softkey returns to the mode selection softkeys.
MSG
MSGBACKBKSP
IDENT
76543210
STBY ON
ALT VFR
CODE
IDENT BACK
XPDR
GND
IDENT
XPDR1
XPDR2
Selecting and activating Transponder 1 or Transponder 2 (Optional):
1) Select the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Select the XPDR1 or XPDR2 Softkey to select and activate the other transponder.
WhenturningontheG1000foruse,thesystemactivatesTransponder1asthedefaultunit,regardlessof
whichtransponderwasactivepriortoshutdown.WhenswitchingbetweenTransponder1andTransponder2,
thecodeandmoderemainthesame.Ifanewcodeisenteredintheactivetransponder,switchingtransponders
does not bring back the previous code.
TRANSPONDER MODE SELECTION
Modeselectioncanbeautomatic(GroundandAltitudeModes)ormanual(Standby,ON,andAltitudeModes).
The STBY , ON, and ALT Softkeys can be accessed by selecting the XPDR Softkey.
Selecting a transponder mode:
1) Select the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Select the desired softkey to activate the transponder mode.